; Any lines which start with a semi-colon will be ignored
; Blank lines signify the end of a section
; However the first non-commented line must be like below
; where the device name is OXFW911, OXFW900 or OXUF922
Configuration information for OXUF922

[hardware_config]
MasterPIO 4
MasterDMA 2
MasterUDMA 5
SlavePIO 4
SlaveDMA 2
SlaveUDMA 5
MiscConfigByte2 80
DisableDREQ 1
MaxTransfer 9

; a commented out line
    
[1394.bus_info]
bus_dependent_info 00ff5003
Vendor_ID 0030e0
Chip_ID_Hi 02
Chip_ID_Lo 454647
 
[1394.root]
;Node_Capabilities 0083c0
Hardware_Version 00F922 
 
[1394.unitSBP]
;Unit_Spec_ID 00609e
;Software_Version 010483
Firmware_Rev 000015
;Man_Agent_Offset 00c000  
;Unit_Characteristics 003c08
;Command_Set_Spec_ID 00609e
;Command_Set 0104d8
;Command_Set_Rev 000000
;Reconnect_Timeout 000003
;Fast_Start 000010
;Revision_Entry 000001
;Dependent_Info_Lun0 5f0000
Model_Number_Lun0 000001
;Dependent_Info_Lun1 5f0001
;Model_Number_Lun1 000000

 
[vendor_name]
"Oxford Semiconductor Ltd."
 
[device_type]
"OXUF 922"
 
[master_name]
"OXFORD IDE Device 1"
 
[slave_name]
"OXFORD IDE Device 2"
  
[USB]
 
[USB.Device]
Vendor_ID 0928
Product_ID 0
Device_Release 0
 
;[manufacturer_name]
; This will be used for USB only but will be ignored if vendor_name has already been set
 
[product_name]
"OXSEMI Mass Storage"
 
[serial_number]
"ABCDEF0123456789"
 
[interface_name]
"Interface0"
 
[configuration_name]
"Config0"

